HOW TO USE Please read all directions before using.
Just follow these step-by-step directions when using E-6000®:
Amazing E-6000 should be used in a well-ventilated area.
Surface should be clean, dry, and free from dirt. For best results, roughen surface before use. Best when used between 70 °F (21 °C) and 85 °F (29 °C).
Always test a small area to ensure proper application technique and dry time.
Apply E-6000 directly to each surface to be bonded or repaired.Allow E-6000 to partially cure, 5-10 minutes, before bringing surfaces together. Amazing E-6000 hardens by solvent evaporation and forms an immediate bond that is difficult to re position after both adhesive-coated surfaces are placed in contact with each other and sufficient pressure is exerted to establish full contact.
For maximum strength, allow to dry for 48 hours. Cure time increases with lower temperatures and decreases with higher temperatures.
Keep threads at the neck of the tube free of E-6000 residue. To ensure easy cap removal, apply a thin coat of petroleum jelly to the threads of the tube before replacing the cap.
Clean uncured adhesive with small amounts of acetone or naphtha; the adhesive will ball up and brush off. Cured material may be removed by cutting or scraping.
Store unused E-6000 at room temperature with cap tightened.